Kurth Electronic KE7100 Blauw

Checks for wiring errors in Network cabling
- Cable length measurement (TDR)
- Blink-identifies switch ports using Link activity lights
- Power over Ethernet Test to IEEE802.3af standard
- High power trace tone signal to use with Probe KE310
- Master identifies up to 32 individual Remotes
- Master and Remotes over voltage protected to 100 Volt
- identifies the majority of the network wiring faults and
- wire-map errors

The KE7100 LANcheck is the light version of the top of the line model KE7200 Ethernet Performance Tester and is an easy-to-use tool for verification and troubleshooting in small and big networks.
Wire mapping including fault location and detection of split pairs, TDR length measurement and Power over Ethernet Test.

KE7100 tests for wire continuity, opens, shorts, miswires and split pairs and shows test results on the easy to read graphical display with backlight. The length of the cable and distance to fault (short or open) is also shown by the KE7100.

The KE7100 can perform a Power over Ethernet Test (IEEE802.3af). KE7100 not only checks for ability of Power over Ethernet, it detects the type available and what power level is supported. PoE is appearing more commonly as devices like wireless access points (WAP), IP cameras and IP telephones grow in popularity. Mismatches between equipment and power supply can cause a variety of problems.

The KE7100 is a easy to use handheld tester with powerful features and an outstanding cost/performance ratio.