Max ICT B.V. maakt gebruik van cookies en vergelijkbare technieken voor functionele, analytische
en marketing-doeleinden. Onze functionele cookies zorgen voor een goed werkende website. De
analytische cookies helpen ons om te ontdekken hoe klanten onze site gebruiken, zodat wij deze
kunnen verbeteren. Daarnaast gebruiken we marketing-cookies, waardoor wij advertenties op jouw
interesses kunnen aanbieden.
Klik op “Alle cookies toestaan” om te ze te accepteren. Kies je voor weigeren? Dan plaatsen we
alleen functionele en analytische cookies. Je kunt je voorkeuren aanpassen door op ‘voorkeuren
aanpassen’ te klikken.
Deze website maakt gebruik van verschillende soorten cookies. Sommige cookies worden geplaatst door diensten van derden die op onze pagina's worden weergegeven. Zie ook onze Privacy Policy en ons Cookiebeleid. Maak hieronder de keuze welke cookies je wilt gebruiken.
For fixed installation. Slim design with charger integrated in the holder. The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior. The charging device is integrated in the holder itself, so there is no large charging box on the cable.
12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended.
The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. The holder fits devices both with standard and extended battery. Attach onto ProClip Mounting Platform. Please read all of the instructions and look at the pictures before attaching the holder. Important Note: Route the cable from the holder into the vehicle dashboard and route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel.
3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.